Menu
Your Cart

Indoor led driver 30w IP20 - 3 years warranty

Indoor led driver 30w IP20 - 3 years warranty
Indoor led driver 30w IP20 - 3 years warranty
Indoor led driver 30w IP20 - 3 years warranty
Indoor led driver 30w IP20 - 3 years warranty
Indoor led driver 30w IP20 - 3 years warranty
Indoor led driver 30w IP20 - 3 years warranty
Indoor led driver 30w IP20 - 3 years warranty
Based on 0 reviews. - Write a review
Add to Cart
Add to Wish List Compare this Product
Features:
1.Protections:short circuit/over load/over voltage/over temperature
2.Design for indoor installations
3. Cooling by free air, high reliability
4. 100% full load burn-in test
5. Suitable for internal lights application for Ⅰ/Ⅱ/Ⅲ.
6. Widely used in LED lighting and IT equipment
7.Compliance to worldwide safety regulation for led lightings.
Specification
 Model: 12V-30W 24V-30W
Input Rated voltage:   90V～130VAC/    170V～250VAC
Frequency: 50～60 Hz
Input Current 0.28A/230VAC or 0.48A/115VAC
Power factor PF>0.6
No-load power consumption <3W
efficiency ( typ.) 84% 85%
Control surge capability L,N:2KV L,N-PE:4KV
Inrush current ( typ.) Cold star 45A at 230VAC
Leakage Current Max.0.5mA
Output Output voltage (loading): (12±0.5)VDC (24±0.5)VDC
Output current (Loading): Max 2.5A Max 1.25A
Output  Power Max 30W
Ripple and noise ≤120mV ≤240mV
Linear Regulation ±1%
Load Regulation ±1%
Start -up Time ( typ.) 600ms/230VAC         800ms/115VAC
Hold  up Time ( typ.) 100ms/230VAC         100ms/115VAC
Protection
Overtemperature 		Protection type: Turn off the output voltage, after the temperature drops, re-energize to restore.
Over Load Protection Shut down the output when current load ≥110%~150%, auto recovers. Over load protection
Short-circuits Protection Protection type: It can be automatically restored after the fault is eliminated.
 
Environment 		Working Temperature ta:－30℃～50℃    tc:80℃
Working humidity 20%～99% RH，Non-condensing
Storage Temp.,humidity  －40℃～＋80℃/10%～95%RH 
Safety
&EMC 		Withstand voltage I/P-O/P：3.75KVAC  
solation resistance  I/P-O/P：100M ohms/500VDC/25℃70% RH
EMC Test Standards EN55015:2013;EN61547:2009;EN61000-3-2:2014; EN61000-33:2013
Safety standards IEC/EN61347;IEC/EN60950;IP20
Reliability and
Quality Control 		Impact aging 100% of the product is fully loaded and impacted for 4 hours under an environment of at least 40°C±5°C
Component derating  Under the steady-state conditions of rated input and output, the stress of components will not exceed its maximum nominal value
Note 1. All parameters not specifically mentioned are measured at  rated load and 25°C ambient temperature.
2. Ripple and noise test method: connect 0.1uF and 47uF capacitors in parallel at the terminal,
    and measure under 20MHZ bandwidth
3. Ensure that the power supply is used under the rated parameters and environment value